SAM4S ELLIX 40 ETHERNET PRINTER

TO PROGRAM THE ELLIX 40 PRINTER YOU WILL NEED THE SETUP UTILITY AND A CROSSOVER CABLE.

 

HOLD THE FEED BUTTON AND TURN THE PRINTER ON — KEEP FEED HELD UNTIL THE RECEIPT WITH THE SETTINGS PRINT OUT.

 

ON THE TOP YOU WILL SEE THE CURRENT PRINTER I.P. ADDRESS

 

PLEASE CHANGE YOUR COMPUTER I.P. ADDRESS SO IT IS IN THE SAME RANGE.

(NETWORK AND SHARING CENTER—LOCAL AREA CONNECTION—CHOOSE TCP/IP V4 PROPERTIES THEN SPECIFY AN I.P. ADDRESS)

EG THE PRINTER MAY PRINT 192.168.0.254 SO PROGRAM YOU COMPUTER I.P. ADDRESS TO 192.168.0.1

 

CHOOSE THE PRINTER TYPE AS 40E FROM THE DROPDOWN LIST

 

RUN THE UTILITY THEN CLICK ON FIND PRINTER AFTER PLUGGING THE PRINTER IN EITHER DIRECTLY WITH A CROSSOVER ETHERNET CABLE OR INTO A NETWORK SWITCH.

 

THE PRINTER WILL BE SHOWN ON THE SCREEN

 

CLICK ON THE PRINTER THEN CLICK ON CHANGE SETTINGS.

 

YOU CAN NOW TYPE A DIFFERENT I.P. ADDRESS EG 10.138.1.222 SET THE PORT TO 9100 TO LINK WITH ICR !!

 

CLICK ON SAVE

 

THE PRINTER FLASHES AND THE NEW SETTINGS ARE SAVED IN THE PRINTER

 

TO CONFIRM IT IS CORRECT TURN THE PRINTER OFF HOLD FEED AND TURN BACK ON AGAIN HOLDING FEED UNTIL THE RECEIPT PRINTS WITH THE NEW I.P. ADDRESS ON.

Langley Distribution has written 42 articles