POSBANK SETTINGS FOR ICRTOUCH

REAR DISPLAY

GOTO PROGRAM 3—SYSTEM PROGRAMMING I/O PARAMETERS

ON THE SETTINGS IN COM 4 SET

BAUD RATE—9600

PARITY—NONE

DATA BITS—8

DEVICE CONNECTED PRESS ENTER AND CHOOSE THE UPX 500 DISPLAY THEN EXIT

GOTO THE DEVICE CONNECTION SETTINGS SCROLL DOWN TO THE REAR DISPLAY AND CHOOSE CONNECTED IT TO COM 4

CASH DRAWER

GOTO PROGRAM 3—SYSTEM PROGRAMMING I/O PARAMETERS

ON THE SETTINGS IN COM 5 SET

BAUD RATE—9600

PARITY—NONE

DATA BITS—8

DEVICE CONNECTED PRESS ENTER AND CHOOSE THE POSBANK RS232 DRAWER THEN EXIT

GOTO THE DEVICE CONNECTION SETTINGS SCROLL DOWN TO THE REAR DISPLAY AND CHOOSE CONNECTED IT TO COM 5

MSR—TO ADD IT TO THE MACHINE TAKE OFF THE COVER TO EXPOSE THE MSR BOARD

THEIR ARE TWO CABLES COMING FROM THE MACHINE MAKE SURE YOU TAKE THE CABLE WHICH IS MARKED USB MSR AND PLUG IT INTO THE TO CONNECTOR ON THE MSR BOARD.

 

***** PLEASE NOTE PLUGGING THE CABLE WHICH SAYS MSR COM6 IN CAN DAMAGE THE MACHINE *****

 

TO CHANGE SETTINGS ON A POSBANK A7 OR A10 PRINTER

HOLD THE POWER AND FEED BUTTONS FOR ROUGHLY 5 SECONDS FIRSTLY A RECEIPT WITH INFO WILL BE PRINTED THEN KEEP THE BUTTONS HELD UNTIL A RECEIPT WITH PRINTER SETTINGS IS PRINTED. THEN LOOSE THE BUTTONS AND PRESS THE FEED BUTTON THE CORRECT NUMBER OF TIMES TO CHANGE THE OPTIONS REQUIRED. WHEN FINISHED TURN THE PRINTER OFF THEN BACK ON AGAIN.

 

COMMON QUESTIONS

 

WHY DOES MY TOUCHSCREEN NOT WORK ?

 

PLEASE LOOK AT THE MODEL NUMBER OF YOUR POSBANK IF THE MODEL SHOWS D510 THEN LOAD THE EGALAXY TOUCHSCREEN DRIVERS FOUND ON THE HARD DRIVE.

IF THE MODEL SHOWN IS D525 PLEASE LOAD THE ELO TOUCHSCREEN DRIVERS.

 

BOTH EGALAXY AND ELO NEED TO BE SET TO COM 5

 

WHY IS THE DRAWER NOT OPENING ?

 

PLEASE MAKE SURE THE SOFTWARE IS NOT IN DEMO MODE—PLEASE MAKE SURE YOU HAVE A DONGLE PLUGGED IN TO THE MACHINE.

Langley Distribution has written 42 articles